I have used the software and added a FESTO Beltdrive + coupling and I get a Reflected Inertia to Motor of double of what I expect to get. The drive is a DGE-63-2000-KF-GK with Inertia of 0.13139 kgm2 and a calculated coupling moment of inertia of 0.0004227 kgm2. No gearbox used and the Inertia reflected to Motor shown on the Motor sizing screen is 0.25739 Nm*s2. How does this Inertia get computed?
Page
1
posts 1–2 of 2
+0
permalink
+0
permalink
Hi!
Do me a favor and send your application file directly to the e-mail address you find at http://www.copperhillmedia.com/contactus.html (I don't want to post it here due to pesty spammers who may find it here...).
I will have a look at it and give you another feedback.
Regards,
Wilfred
Page
1
posts 1–2 of 2
This Topic Is Locked To Guest Posts
It's been a while since this topic was active, if you'd like to get it going again, please post as a registered member
